Start with the water, then the pipes
Winston-Salem/Forsyth County Utilities draws its water from the Yadkin River and Salem Lake. Its 2025 water quality report gives an average hardness of 17.5 ppm (range 9 to 28) and an average pH of 7.5, and says orthophosphate is added "to prevent pipe corrosion" (City of Winston-Salem). The same report lists lead at the 90th percentile as not detected, and points to the utility's service line map.
Our reading: soft, treated water is not the usual cause of scale. So if the water runs brown or weak at your house but not next door, look at your own pipes first. A plumber can confirm it.
How old are the houses?

Citywide, the median home was built in 1984, and about 1 in 4 before 1960 (Census ACS 2024; the 1960 share is our math). Some of the older neighborhoods:
| Neighborhood | Built | Source |
|---|---|---|
| West EndQueen Anne, Colonial Revival, Classical Revival, Craftsman bungalows | 1887–1930 | Wikipedia |
| Washington ParkColonial Revival, Craftsman, Queen Anne | 1892–1940 | Wikipedia |
| ArdmoreQueen Anne and Craftsman | from about 1910 | Wikipedia |
| Buena VistaA 1920s bedroom community | 1920s on | City of Winston-Salem |
These are dates for the buildings, not for their pipes. Many houses have had some plumbing replaced since.
Signs the pipes are tired
- Brown or yellow water that clears after a few seconds of running, worst after the water sits overnight.
- Pressure that drops, often first at the fixtures farthest from the main.
- The same leak coming back, or new leaks in different spots.
- A metallic taste in cold water.
- Age. One guide puts galvanized steel at 40 to 80 years, depending on water and conditions (Repipe Solutions, a repiping contractor). It also warns that a pipe can look clean outside and be mostly blocked inside.
- Polybutylene. A cost guide says it was used from 1978 to 1995 and has a known high failure rate (EstimatorSuite).
Repair, or repipe the whole house?
A repair may be enough if
- One leak, one fixture, one bad valve.
- The water is clear and the pressure is steady.
- The pipe is newer and the trouble is local.
Ask about a repipe if
- Leaks keep showing up in new places.
- Pressure has fallen throughout the house.
- The water runs brown most mornings.
- The plumber finds old galvanized or polybutylene lines.
What a repipe can cost
One cost guide puts a whole-house repipe at $4,000 to $15,000, averaging about $7,500 for a 2,000 sq ft house with two baths. PEX runs $4,000 to $10,000 and copper $8,000 to $18,000. Opening and patching walls can add $1,500 to $3,000 (EstimatorSuite, 2026). That is a national, cost-guide figure, not a Winston-Salem quote. Get at least two written quotes. See all of our price rows.
Permits and licenses in Forsyth County
A repipe is plumbing work, and North Carolina requires a permit for installing, extending or generally repairing a plumbing system (G.S. 160D-1110). In Winston-Salem and most of Forsyth County, the Inspections Division issues plumbing permits (336-727-2624). Kernersville's Development Services handles its own (336-996-7166). Check the plumber's license on the NC license search.
Ask before you say yes
- What pipe material are you proposing, and why?
- Will you pull the permit, and is the fee in the price?
- How much wall or ceiling will be opened, and who repairs it?
- How long will the water be off each day?
- What does the warranty cover, in writing?